预旋喷嘴径向角度对预旋特性影响的数值研究

为了降低低位进气预旋流路的气动损失，针对带有不同径向角度（0°~30°）预旋喷嘴的预旋系统进行了数值仿真，并对流动特性、温降特性和比熵增特性进行了分析。结果表明:随着预旋喷嘴径向角度的增大，预旋系统无量纲温降先增大后减小，流动阻力减小，预旋系统的流量随之增大。旋转雷诺数为2.3×107时，预旋喷嘴带径向角度的预旋系统无量纲温降比传统喷嘴最大可提高18.3%，存在某一角度使预旋温降特性达到最好。预旋系统内的耗散主要发生在预旋腔和共转盘腔内，径向角度为10°时其比熵增变化量分别占整个预旋系统总体比熵增的42.4%和30.2%；合理设计预旋喷嘴的径向角度，能改善预旋腔内气流的流动效果，并且可以减少整个预旋系统的不可逆损失。      

摆线桨非定常动态失速的三维效应

对摆线桨三维全尺寸模型进行了非定常数值模拟。验证了两种嵌套网格方法的可靠性与适用性,针对二维/三维情况下摆线桨非定常涡流动特性及诱导分离特性开展了数值分析,重点研究了展向气动力随方位角的分布与全局流场的诱导速度分布,并分析了尾迹捕捉精度与涡量耗散特征。结果表明:受摆线桨切向速度、展向诱导速度等三维效应影响,两种计算结果的瞬态气动力极值差值达到44%。三维动态失速涡的产生、脱落与再附明显弱于二维翼型情况,这对于摆线桨非定常气动特性有较大影响。      

扩压叶栅叶尖非定常流动的涡动力学机理

为了揭示压气机叶尖区旋涡结构与流动非定常性之间的关联，采用URANS对一亚声速平面扩压叶栅在不同攻角下的流场进行了求解，并借助Q判据提取了叶尖瞬态涡系结构。结果表明：泄漏涡的破碎现象能够通过诱导新的涡结构间接作用于相邻通道的叶尖流动，是导致叶尖流场失稳的关键因素。在-0.3°和+0.7°攻角下，叶尖泄漏涡发生了螺旋破碎，并伴随有非定常诱导涡的出现，诱导涡对相邻叶片载荷的影响使得叶尖泄漏涡发生周期性摆动；在+1.7°攻角下，泄漏涡破碎会导致反流涡的形成，反流涡的输运会给叶片载荷和来流攻角带来非定常扰动，反过来又会作用于泄漏涡的破碎和反流涡的生成，最终表现为一种自维持的非定常流动现象。     

Numerical investigation on flow nonuniformity-induced hysteresis in scramjet isolator

Numerical simulation and theoretical analysis were conducted to study the hysteresis inside scramjet isolator during the reciprocating process of back pressure variation. It is revealed that only a regular reflection is theoretically possible for two leading shocks when the inflow Mach number is greater than 2.0, and no hysteresis can occur in the transition between shock reflection types. Nevertheless, wall suction, gas injection, and background waves cause non-uniformity of the incoming flow and would make hysteresis possible. Besides the classical hysteresis in the transition between shock reflection, new kinds of hysteresis were found in both the deflection angle of separated boundary layer and the location of the shock train. Moreover, the occurrence of hysteresis in the deflection angle of the separated boundary layer is accompanied with the shock reflection hysteresis. In the case with background waves or gas injection, hysteresis in the starting position of leading shock was observed too. As back pressure decreases, the leading shock does not follow the same path as that as the back pressure increases, and it is anchored at the location where the background shock or the injection interacts with the leading shock. It is inferred that, if two strong adverse pressure gradient regions move towards and interact with each other, hysteresis will take place when they start to separate.     

静电场仪校准系统的设计及仿真研究

静电场仪的精确校准对提高卫星在轨电场探测精度、保障卫星安全发射升空、精确预测雷电等具有重要意义。针对电场仪校准的需要，设计了平行极板电容式静态电场仪校准装置。利用三维电磁场仿真软件CST对标准静电场发生装置进行数值仿真，研究了校准箱内部及边缘处的静电场分布特点，分析标准极板直径和间距对边缘效应的影响，结合极板平行度对电场均匀性的影响分析，确定了校准过程中电场仪探头的最佳位置，实现静电场仪校准装置的最优化设计。     

Unsteady wakes-secondary flow interactions in a high-lift low-pressure turbine cascade

Detailed experimental measurements were conducted to study the interactions between incoming wakes and endwall secondary flow in a high-lift Low-Pressure Turbine (LPT) cascade. All of the measurements were conducted in both the presence and absence of incoming wakes, and numerical analysis was performed to elucidate the flow mechanism. With increasing Reynolds number, the influence of the incoming wakes on suppressing the secondary flow gradually increased owing to the greater influence of incoming wakes on reducing the negative incidence angle at higher Reynolds numbers, leading to a lower blade loading near the leading edge and suppression of the Pressure Side (PS) leg of the horseshoe vortex. However, the effect of unsteady wakes on suppressing the profile losses gradually became weaker owing to the reduced size of the Suction Side (SS) separation bubble and increased mixing loss in the free-flow region at high Reynolds numbers. Incoming wakes clearly improved the aerodynamic performance of the low-pressure turbine cascade at low Reynolds numbers of 25,000 and 50,000. In contrast, at the high Reynolds number of 100,000, the profile loss at the midspan and mass-averaged total losses downstream of the cascade were higher in the presence of wakes than in the absence of wakes, and the unsteady wakes exerted a negative influence on the aerodynamic performance of the LPT cascade.     

场协同原理在高超声速化学非平衡流动中的推广

应用理论分析与数值模拟方法，将对流传热的场协同原理从不可压缩流动推广至高超声速化学非平衡流动中。结果表明，高超声速化学非平衡层流与湍流的热流密度取决于流动的当地单位体积的动量与单位质量总焓梯度的协同。用当地单位体积的动量与单位质量总焓梯度的协同研究高超声速化学非平衡流动的壁面传热问题，对层流流动下的对流传热，不但计及了高超声速化学非平衡流的密度变化对热流密度的影响，而且包括了静焓梯度、压力梯度、边界层内的分子黏性剪切效应对热流密度的作用；对湍流问题，除了上述层流流动各项对热流密度的影响外，还计及了雷诺剪切应力对热流密度的作用。考虑到高超声速化学非平衡流静焓的定义，高超声速化学非平衡层流及湍流的场协同同时计及所有组分的平动能、转动能、振动能及电子能等梯度的贡献。     

沸腾换热在水卡式大热流传感器研制中的应用

为了实现MW级热流环境的长时间稳态测量,研制了一种新型结构的水卡式大热流传感器。该传感器采用U型水冷通道结构,基于沸腾换热理论进行换热设计,设计量程5~15 MW/m~2。在高温超声速燃气流试验台上进行了热流测试试验,实际测试量程3~25 MW/m~2。沸腾换热理论的应用可以在较小的水流速下实现MW级热防护,大大降低了设计难度。新型结构传感器相对传统的中心冲击结构换热效率更高,可实现的量程范围更大。     

叶片冷却的静叶时序对涡轮的性能影响

燃气轮机工作过程中上游叶片的尾迹会周期性地扫掠下游叶片,这使得下游叶栅通道内的流场呈现显著的非定常性。而时序效应作为一种典型的非定常流动现象,已受到国内外学者的广泛关注。本文研究双级气冷涡轮,利用全三维非定常数值仿真的方法分析了第1级与第2级静叶之间的时序位置对涡轮流量和效率的影响。计算结果表明处于不同时序位置下的涡轮第2级静叶叶身冷气流量的差异可达15.6%,涡轮41截面效率和热效率的波动幅值则分别达到了0.33%和0.26%。涡轮冷气流量的变化一定程度上影响了41截面效率,但时序位置对下游叶栅通道流动损失的影响才是造成涡轮效率差异的主要原因。     

A boundary vector cell model of place field repetition

Hippocampal place cells are thought to form the neural substrate of a global cognitive map. However, in multicompartment mazes, these cells exhibit locally repeating representations, undermining the global cognitive map view of place cells. This phenomenon appears to be related to the repetitive layout of these mazes, but still no hypothesis adequately explains it. Here, we use a boundary vector cell (BVC) model of place cell firing to model the activity of place cells in numerous multicompartment environments. The activity of modeled place cells bears a striking resemblance to experimental data, replicating virtually every major experimental result. Our results support the BVC model and indicate that locally repeating place cell firing could result purely from local geometry.